Jensen UV9 User Manual download pdf (Page 6)

UV9

Optional Equipment

• NAV101/NAV102

The UV9 is "navigation ready." Before accessing any

navigation features, you must purchase and install the

avigation module (NAV101 or NAV102). All installation

and operating instructions will be included with the

navigation module.

Once the navigation module is connected and operating

properly, the NAV source mode will become active.

While the navigation module is not installed, the NAV

option appears gray, indicating the function is not

available.

• Rear Camera

The UV9 is "camera ready." Before accessing any

camera features, you must purchase and install a rear

video camera. Once the rear camera is connected and

operating properly, the CAMERA source mode will

become active. While the camera is not installed, the

CAMERA option appears gray, indicating the function is

not available.

What’s in the Box

1. UV9 Head Unit

2. Single DIN sleeve

3. Wiring harness

4. Parking brake sensor extension wire

5. Mounting hardware

6. Cosmetic trim ring

7. Remote Control

8. Owners Manual

9. Quick Start Guide

Tools and Supplies

You will need these tools and supplies to install your UV9:

• Torx type, flat-head and Philips screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screwdriver, socket

wrench set or other tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

WARNING! Only connect the unit to a12-volt power

supply with proper grounding.

WARNING! Never install this unit where operation and

viewing could interfere with safe driving conditions.

WARNING! To reduce the risk of a traffic accident (except

when using for rear view video camera) never use the

video display function while driving the vehicle. This is a

violation of federal law.

WARNING! Never disassemble or adjust the unit.

WARNING! To prevent injury from shock or fire, never

expose this unit to moisture or water.

WARNING! Never use irregular discs.

WARNING! To prevent damage to the mechanism inside

this unit, avoid impact to the TFT monitor.

WARNING! Using an improper fuse may cause damage

to the unit and result in a fire.

WARNING! The monitor employs an automatic motorized

mechanism. To prevent damage to the core mechanism,

please do not push, pull or swivel the monitor manually.

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and

remove the negative (-) battery cable prior to installation.

NOTE: If the UV9 is to be installed in a car equipped with

an on-board drive or navigation computer, do not

disconnect the battery cable. If the cable is

disconnected, the computer memory may be lost. Under

these conditions, use extra caution during installation to

avoid causing a short circuit.

1 2 3 4 5 6 7 8 9 10 11 ... 83 84

Comments to this Manuals

No comments

Jensen UV9 User Manual Page 6

Comments to this Manuals

Related products and manuals for Car Video Jensen UV9