Jensen JIMS-70I User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
6
BATTERY CARE
i. If the unit is not used for an extended period of time, remove the battery. An old
or leaking battery can cause damage to the unit and may void the warranty.
ii. Do not dispose batteries in fire. Batteries may leak or explode.
iii. Do not try to recharge batteries that are not intended to be recharged; they can
overheat, rupture and leak (Follow battery manufacturer’s directions).
iv. (a) Do not mix old and new batteries.
(b) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
AC Adaptor Operation
1. Insert one end of the AC adaptor into the DC Jack on back of JiMS-70i.
2. Connect the AC plug of the AC adaptor to an AC 120V~ 60Hz power source.
Note:
Unplug the AC adaptor and disconnect the DC Jack when the JiMS-70i is not in
use for a long period of time.
CLOCK SETTING
NOTE:
i.
The clock has to be set the first time you plug the unit in.
ii. The Clock is set to default in 12 Hour format mode.
Setting the Time Manually
When the AC adaptor is plugged into a 120V ~ 60 Hz power outlet, the clock
display will light flashing “12:00”.
1.) To set the hour, press and hold the MEMORY/SET button until the hour digits
flash.
2.) While the hour digits are flashing, repeatedly press the
or buttons to
select the correct hour digits.
NOTE:
Make sure the hour is set so that AM or PM is displayed correctly. There is a PM
Indicator located in the bottom right corner of the Display. The displayed time is
PM
when the indicator is lit. The displayed time is
AM
when the indicator is off.
3.) Press the MEMORY/SET button to confirm the hour setting and the minute
digits will flash to prompt for input.
4.) While the minute digits are flashing, repeatedly press the
or buttons
until the correct minute digits are displayed.
5.) Press the MEMORY/SET button again to complete the clock setting.
TIME SYNCHRONIZATION
The JiMS-70i features a “SYNC” button that allows you to set the time using the
internal clock of the iPod/iPhone.
With the iPod/iPhone docked and power OFF, press the “
SYNC
” button once.
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments