Jensen JiMS-198i User Manual download pdf (Page 18)

Note:

If you connected the Line Out Jack of your external device then you only need to adjust

the volume control of this system. If you connected the Headphone Jack of your external

device then you may need to adjust both the volume control of your external device and

the volume control of this system to find the most desirable volume setting.

- Do not subject the unit to excessive force, shock, dust or extreme temperature.

- Do not tamper the internal components of the unit.

- Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.

- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.

- Keep your unit away from heating appliances and sources of electrical noise such as

fluorescent lamps or motors.

Resetting the Unit

If the unit is subject to a power surge or electric shock, it is possible that the internal

micro-controller may lock up and the unit will not respond to any commands from the top

panel controls or remote control.

1. In this event, unplug and then reconnect the AC power plug into the wall outlet.

2. Use a straightened paper clip, toothpick or similar objects to press the RESET button

located on the side of the main unit (see the below figure). The reset operation clears

the system memory and all of your previous settings will be erased.

CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET

BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.

CARE AND MAINTAINANCE

RESET

1 2 ... 13 14 15 16 17 18 19 20

No comments

Jensen JiMS-198i User Manual Page 18