JENSEN BT250 BBlluueettooootthh CCaarr KKiitt UUsseerr’’ss MMaannuuaall Installation and User Manual
Bluetooth Car Kit User Manual 6 GGeettttiinngg SSttaarrtteedd Introduction The Bluetooth Wireless Car Kit is designed to help make your driving ex
Using the remote control The Car Kit is operated using the remote control: Control Module Functions Volume up / down Press during operatio
Bluetooth Car Kit User Manual 8 Disconnect / voice recognition Press to disconnect a call. Press and hold for two seconds to activate the Voice Re
Turning off the BT250 & the Blue LED light When the BT250 is not connected to any phone the Blue LED light will continue to flash. You can tur
Bluetooth Car Kit User Manual 10 Resetting the Car Kit The car kit may only connect to one phone at a time. However, it may be paired with up to
the way you say the voice tag, but also record a familiar background noise. Since phones are in continual contact with the Car Kit, it is possible
Bluetooth Car Kit User Manual 12 Troubleshooting My mobile phone can’t make a connection. • Make sure the bluetooth function on your phone is ena
Warranty Information 12 MONTH LIMITED WARRANTY Applies to Jensen Series Mobile Electronics. AUDIOVOX Electronics Corporation (the Company) warrants
Bluetooth Car Kit User Manual © 2009 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 14
iPreface This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights re
Bluetooth Car Kit User Manual ii Preface...
BBlluueettooootthh WWiirreelleessss CCaarr KKiitt Installation This section demonstrates how to set up and install the Bluetooth Wireless Car K
Bluetooth Car Kit User Manual 2 Installing the junction box This Car Kit is designed to work with a 12/24-volt vehicle power supply. Refer to the fo
Connecting the power supply The following illustration demonstrates how to connect the Car Kit’s power cable to the vehicle’s electrical system. Po
Bluetooth Car Kit User Manual Connecting Components The following illustration shows where to connect the devices. Do not connect the components until
Installing the Components Before installing the components, take note of the following: • Make sure that the cables can reach from the each compon
Comments to this Manuals