® Docking Digital Clock Radio For iPod and iPhone USER MA
9during playback for fast forward searching within the song. 5.) Press the Button to go to the starting point of current song or previous song. Pr
10Note: “b” stands for Wake to Alarm, “I” stands for Wake to iPod/iPhone, and “F” stands for Wake to Radio. i. Wake to Alarm (b) - Repeatedly pres
11Note: i. The relevant Alarm Indicator will blink when the alarm time is reached. ii. If you have chosen the “Wake to RADIO” alarm mode, make sure
12Note: (1) If you connected the Line Out Jack of your external device then you only need to adjust the volume control on JiMS-70i. If you connected
13AC Adaptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Plug the AC adapto
14 Frequency FM: 88 – 108 MHz “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect spec
15any part thereof, except batteries, when it is returned to the SPECTRA Service Department, accompanied by proof of the date of original consumer pu
1DEAR JENSEN® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now i
2IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However
3IMPORTANT NOTES Avoid installing the unit in locations described below: Places exposed to direct sunlight or close to heat radiating appliances su
4PRODUCT FEATURES The JiMS-70i is an iPod/iPhone Docking Music System that incorporates the following features: Play and Charge your iPod nano, i
58. Snooze/Sleep/Dimmer Button 9. iPod/iPhone SKIP Forward ; Radio TUNE+ Button; Clock Adjust Forward; Memory Up 10. Volume Up (+) / Alarm1 Set But
6BATTERY CARE i. If the unit is not used for an extended period of time, remove the battery. An old or leaking battery can cause damage to the unit
7NOTE: When you first dock your iPod/iPhone, the unit will run an authentication process, so it may not respond immediately to the SYNC button whe
8example, if it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning method to "fine tune" to the exact frequency of the desired
Comments to this Manuals